1) Remove the heat shield from the backup light compartment in the tail light assembly. It is not necessary with and LED lamp and may block some of the lamps light. 2) Fabricate a reflector. Start with a 20 oz. Gatorade bottle or similar. Note from the photos that one side is cut shorter for a better fit. The shorter side is positioned to the top of the light assembly. cover the inside of the reflector with wedges of reflective aluminum foil tape as shown in the photos. This inexpensive tape is often used to seal air conditioning ducts and dryer vents. The reflector is captive and does not need to be glued in place. 3) Choose an LED lamp with about 1000 lumen output. Be careful. Sometimes manufacturers sell them in pairs and list the combined output instead of per lamp. While the reflector captures much of the radial light, axial light goes directly to the backup light lens. I chose: AUXITO 1156 BA15S 7506 LED Backup Reverse Lamp Bright White 6500K 1200Lm/per bulb 9-18V - 0.58A 7W/per bulb $11.59 for package of 2 on ebay This lamp send about 55% of its total light axially out the rear of the van. 06/09/20 - Mike - wa7zpu@5by9.net